![]() Bed/nozzle temperature also has an effect. This occurs when the bed is high and/or the bottom layer flow rate is too high. File and sand the ends of the strings flat.Ī flared base is when the bottom few layers of the print flare outwards and are larger than they should be.Use a sharp hobby knife to remove the bulk of any stringing.Stringing occurs when the hot nozzle moves to another point within a print-layer and draws out a thin fiber of plastic. The reason we added small circular discs to the tiles was to prevent the corners from lifting and warping. The severity of these issues depend on how well tuned your printer is. When a 3D print is finished printing there are often some small issues with the part that need to be addressed including stringing and a flared base. 1x dragon (we thought a ferocious dragon terrorising the lands was much cooler than a robber).1x each of the field/grain resource (4 total).1x each of the forest/lumber tiles (4 total).1x each of the pasture/wool titles (4 total).1x each of the mountain/ore tiles (3 total).1x each of the hill/brick tiles (3 total).In fact all your tiles can be the same color! However if the filament color is close to the final color of the tile then bad paint-jobs are less noticeable. Layer height for dragon/cities/settlements/roads: 0.1mm.Layer height for hex tiles: 0.2mm (you can go lower to get a more detailed print but the time will increase).Infill: 5% (these are not structurally critical parts).The amount of 1.75mm PLA filament used was roughly 700 grams. The total time taken to print all the models was around ~80 hours. We 3D printed all our models on our Anycubic i3 Mega. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |